zcM1000 Cutting Head Connector Replacement

Removing Old Connector:

1. Remove Cutting Head and Pressure Knob from machine
2. Remove 4 of each Screw from Cover and lift Cover off machine.
3. Locate P200 Connector and unplug from Main Board.
4. Remove Connector by unscrewing nut on inside of Cover and pulling Connector out through front on
   machine.

Setting New Connector:

1. Remove nut from P200-1 Connector and slide wires through Cover.
2. Slide nut onto wires and attach P200-1 Connector to Cover.
3. Plug Connector into Main Board.
4. Replace Cover and screws.
5. Replace Pressure Knob and Cutting Head.